« previous next »
Pages: [1]   Go Down

Author Topic: Help!!  (Read 1529 times)

Offline masterkush

  • Guppy
  • *
  • Posts: 8
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Help!!
« on: September 28, 2012, 01:06:14 PM »
I have a xenon MOBO and I repaired the 3 RROD and noticed it still had the RROD , so I noticed my left fan wasn't spinning , so then I switched fans and noticed my right fan wasn't spinning , THEN I switched fans again and my left one wasn't working , what can it be? Please help! ASAP , thanks  :tup:
Logged

Offline Rodent

  • XBOX,XBOX360,PS3,WII
  • Moderator
  • Around the block
  • *
  • Posts: 2983
  • Post quality +75/-5
  • Gender: Male
  • MODDER, REPAIR, CUSTOM IDEAS.
Re: Help!!
« Reply #1 on: September 28, 2012, 02:36:37 PM »
Quote from: masterkush on September 28, 2012, 01:06:14 PM
I have a xenon MOBO and I repaired the 3 RROD and noticed it still had the RROD , so I noticed my left fan wasn't spinning , so then I switched fans and noticed my right fan wasn't spinning , THEN I switched fans again and my left one wasn't working , what can it be? Please help! ASAP , thanks  :tup:
Hard wire them to 12volts  problem solved and will help from getting the rrod :)  good luck any other question besure to ask
Logged

 Tracey: I cant believe Rodent of all people made my damn day
3D0: snacks cartoons and naps  lol sounds like rodents typcial day :rofl:
Rodent consoles mods

Offline masterkush

  • Guppy
  • *
  • Posts: 8
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: Help!!
« Reply #2 on: September 28, 2012, 04:41:48 PM »
Okay so I 12v modded it, and the Xbox jumps straight to the 2 ROD  :dntknw:
Logged

Offline KingMike_OS

  • Shop Owner - Products & Support
  • Acidmods Alumni
  • Acid Modder
  • *
  • Posts: 929
  • Post quality +14/-0
  • Gender: Male
  • R&D
    • Modding Shop At the end of the Universe
Re: Help!!
« Reply #3 on: September 28, 2012, 06:43:14 PM »
the screw on the ROD Repair are Tight

so its over heating need to Losen them Up and do a Hand Tight

or the surface is uneven mean one side Higher than other and if still Acting up with the Fan you Kill the Fan Controller Mosfet

Located at the Buttom of the board .. can test ot easy with voltmeter 
« Last Edit: September 28, 2012, 06:43:52 PM by KingMike_OS »
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal