Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
Xecuter 2.6 CE mod chip & programmer just came in today!!!!!Now I'm waiting on my new 128 mb ram chips and new hard drive / converter board. About time I get this project going yea.
This is where I got mine. Its a store in Canada. Link: http://www.gocybershopping.com/home.php?cat=220Its almost impossible finding instillation diagrams bit I found one that's in French. I'm translating it out into English right now. If u can't find one I can link the schematic I found as well.
Just finishing up my solder install of my 128mb ram upgrade. Got one more Samsung k4d263238f-qc50 ram chip to install!. Install is actually going really fast and smooth. I've checked all my welds and all are lookin great. I'll have to post back when I finish and see if everything workedbout smoothly.
I just used flux paste and a very fine soldering tip with a small flat tip. I didn't add any solder as the pads have enough solder on them. Unfortunately I had my heat up to high @ 400 and one pad lifted. I got it back down but I keep getting the frag green red flashing LED. I bought new chips and did everything to the tee. Even had my eye piece to get real close to check every joint. I used a razor blade to check in between the gaps of each pin. Everything seems as its supposed to be but no dice. I'm pretty beaten up about it and had high hopes for it. I'm going to take a break and think about my options. I'm hoping maybe I can heat gun off the chips I installed and hopefully it won't ram frag me. If not I'll just install my xecuter chip in another motherboard I have and forget all about the ram upgrade. Oh well gave it my all but still wasent good enough.