Author Topic: After market XB1 shells not fitting...  (Read 2306 times)

Offline GrooveZoidberg

  • Chief squatting Hard
  • *
  • Posts: 14
  • Post quality +0/-0
  • Gender: Male
  • My dad totally owns a dealership.
After market XB1 shells not fitting...
« on: April 28, 2015, 09:15:09 PM »
im having trouble with these aftermarket shells.



Every time I put them together, there's always a huge gap right here.

Also, the mic port isn't lined up properly.

Now I understand aftermarket shells are :censored:, but is there a work around? A fix?

I've tried Dremeling down / sanding down all around it, but once those screws are in it seems to pop up every time.

Any insight is appreciated.

Offline Modded Matt

  • Site Owner
  • Administrator
  • Around the block
  • *
  • Posts: 4649
  • Post quality +65/-3
  • Gender: Male
Re: After market XB1 shells not fitting...
« Reply #1 on: April 29, 2015, 05:23:30 AM »
the mobo is not going down enough in the bottom shell. find out what is holding it up. the mic port must lign up or you will have these issues.

aftermarket shells are crap. I have not found any good ones yet.

Offline GrooveZoidberg

  • Chief squatting Hard
  • *
  • Posts: 14
  • Post quality +0/-0
  • Gender: Male
  • My dad totally owns a dealership.
Re: After market XB1 shells not fitting...
« Reply #2 on: April 29, 2015, 10:07:45 PM »
So good to know I'm not the only one.

Yeah I noticed that was the problem too.

It seemed to help if I used the skeleton thing that comes with the shell.  But sometimes they don't come with one.

Have you tried shaving down the area that's pushing up? If so, which area?

Thanks for the reply!

Offline LittleVikingGirl

  • Guppy
  • *
  • Posts: 6
  • Post quality +0/-0
  • Gender: Female
  • Acidmods User
Re: After market XB1 shells not fitting...
« Reply #3 on: April 30, 2015, 02:56:44 PM »
Some of the aftermarket shells have a chunk of plastic on the front faceplate in the center down towards the bottom. This could be what is hanging it up. I've found that it also helps to squeeze the mic port area together when closing it up and screwing the bottom first and then the top.
It also could be that the paint warped the shell and the center is just permanently higher.

Offline GrooveZoidberg

  • Chief squatting Hard
  • *
  • Posts: 14
  • Post quality +0/-0
  • Gender: Male
  • My dad totally owns a dealership.
Re: After market XB1 shells not fitting...
« Reply #4 on: May 02, 2015, 08:50:34 AM »
Going to try that today!!
Awesome advice :)

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal