RGH 1.2 issues when delivered

[thematrix]

I have installed RGH 1.2 on 17 consoles
I use the same exact wire route
I use rev c's and rev d's
On the rev c, i make no adjustments to the chip
On the rev d, i only disable R13
I boot every console 20x before i mail out
I boot 10x in the chassis
I boot 10x all put together
I get boot times instant - 5 seconds, a few 5-10 seconds
I verify every console boots before i ship out
I use timing matrix files 19-21

For some reason 4 of the jaspers and 2 of the falcons buyers - "it doesn't boot" or "it freezes"
I just cant see how it boots perfectly fine before i ship, and then all of a sudden it doesn't work
I have no idea what the buyers do with the console or what they do, dashlaunch, plugins, corrupted files, noobs etc...
I don't know if it's my wire routing, bad chips, i'm missing something or what

Maybe someone here can shed some light, perhaps post their RGH 1.2 wiring diagram for falcons and phats
Here are pics of my wiring setup
Kynar wire for spots A and D
Regular coolrunner wire for ground, power, post out, and, and B
I use a very fine tip for soldering A and D

Pics below are of my beater and it works wonderful

[Rodent]

change your wire loction  and which console is this? jasper or falcon?   if falcon its probably a gpu issue

i had a jasper that was freezing on me once i rewrote the nand and fixed the issue

[thematrix]

change your wire loction  and which console is this? jasper or falcon?   if falcon its probably a gpu issue

i had a jasper that was freezing on me once i rewrote the nand and fixed the issue

which wire(s)? Do you have a diagram?
this is a jaser

I just had another one today. It was a jasper, that booted 20x perfect before i sent out
Customer was happy, all was fine for 2 days. Then today, it's not booting
Customer states that he downloaded a skin to the console and set console to boot to fsd on startup

I just can't see how it works fine, before i ship. then all of a sudden

[Rodent]

which wire(s)? Do you have a diagram?
this is a jaser

I just had another one today. It was a jasper, that booted 20x perfect before i sent out
Customer was happy, all was fine for 2 days. Then today, it's not booting
Customer states that he downloaded a skin to the console and set console to boot to fsd on startup

I just can't see how it works fine, before i ship. then all of a sudden

I have pics on here how i run my wires for rgh1  blue wire runs along the green but ran same way as green for rgh1 as for rgh1.2

Reset Glitch hack Tutorial 

  here is the issue with your customer not all FSD skins work for the latest FSD for newer rgh consoles  only FSD3 skins will work and I also know that if your customs do the same things mine do they have no clue what there doing since there kids around age 10 and up . or n00bs that are just starting to learn so you have to be patient and ask them exactly what they have installed on the console. its nothing that your doing wrong if you have done 20 consoles are more. once in a while you will get a console that doesn't perform like it should . and will not boot like it should  especially coronas they seem to be the toughest to get to boot properly every time.  jaspers  if you do them like rgh1 should be you shouldnt have any issues. I seen your wiring in your pics and what happens is the wires get cut or sliced in them and cause an issue with booting. I just redone 3 of them that a customers have sent me to do rework on