problem rapid fire xbox one firing alone

[fibis11]

Hi everyone, I registered hj, but I have been following the site for a long time, I wanted to discuss a little problem that I am encountering and I can not solve it, my control xbox one 1697 rapid fire, it shoots alone. I already installed hexcreator to change, increase or decrease modes, I already used a cod hex hex 9 modes here from the site, but the problem always persists in continuing, I already changed the local pic to discard some kind of interference, I I read here, that some member already had this problem, but even where I read he had no solution, someone else with the same problem? if anyone can help me thank you very much, thank you

[SethMods]

I am probably not going to be much help here, but you might try the new XBox One Slim compile option that I just added for the HexCreator website.

http://www.diymods.work

The original XBox code did not work on the new Slim controllers. I had to make some tweaks to my timing. Maybe this is related somehow.

Good luck!

[fibis11]

Thank you so much, I'll do a test.

I have a slim control too, I would like to try it, would you have any tutorial of soldering points for slim version?

[SethMods]

I have only tested Power +, Power -, RT, and LT. But they are essentially the same as the older controller.

http://www.diymods.work/downloads/XBox%20One/

RDC could probably help you if you were looking to tie into a specific button and you can't find it yourself.

[fibis11]

thank you


the new compilation xbox slim xcreator did not work in the control version pcb 1697, I returned to original hex code, I reinstalled several times, in several controls, pic12f1822 varied, but the alone shot always happens

Today I used a 1708 control and I used the new compilation (S) and I used the points of the pcb scan 1708 and it was a success, I created a mod of 25 modes. It was perfect, and no error in shooting alone as in the previous version