Author Topic: 1708 replaced sticks but still drifting  (Read 2373 times)

Offline adamp2006

  • Guppy
  • *
  • Posts: 5
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
1708 replaced sticks but still drifting
« on: June 17, 2018, 04:19:12 AM »
Got a 1708 controller that had started to drift , checked it out in the windows controller properties and both left and right sticks were out (right more so than left) , opened it up and replaced both sticks, hooked it back up the pc and checked again and both sticks are still out by the same amount, is there a way to fix this without just junking the board and replacing ? any passives between the stick and the main chip that could have failed (and are accessible to change) ?

Any suggestions (sensible :P ) welcomed

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: 1708 replaced sticks but still drifting
« Reply #1 on: June 17, 2018, 07:20:51 AM »
The only 'easy' thing you can do is desolder the POTs, not the whole stick just the POTs, and kind of turn them in the direction that will eliminate the drift. Depending on how bad they are, you may need to remove the POTs from the stick housing so the little plastic posts of them can be cut off so the POT can then be clipped back on and you'll be able to turn it a bit more.
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline adamp2006

  • Guppy
  • *
  • Posts: 5
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: 1708 replaced sticks but still drifting
« Reply #2 on: June 17, 2018, 11:26:50 AM »
Thanks for the suggestion , will give it a go , may do a dry run on the ones i removed lol

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal