Help please xbox one elite controller

[radek1305]

Hello dear forum members

I am asking for help related to the xbox one controller in the ellite version.

I would like that the "Right Analaog Stick Click" button would be autamaticly pressed down after pressing the "LT" button.

I tried to solder various pins but unfortunately without success.

Could anyone put a picture of the diagram and draw what to solder with.

I will be extremely grateful for your help.

[Modded Matt]

if you need them activated at the same time, that would be easy to do. if you need it pressed one then the other, you will need some form of logic to delay the second press.

[radek1305]

Thank you for your interest in my question.

A small correction was about the "Left Analog Stick Click" not right.

I would like the signal after pressing the LT button from times to be passed to the "Left Analog Stick Click" and run it.

The delay is unnecessary.

Using a piece of wire I tried to connect different pins in the controller and after a day of unsuccessful attempts I gave up so unfortunately for me it is not that easy

[RDC]

You'll never be able to do that with just a wire in that controller, or any controller really.

Depending on how timing specific this is there are a couple of options.

The easiest way to do what you are wanting would be to install some small switch under the LT assembly so that it gets pressed only when the LT is pulled all the way. Then wire that switch up to be a duplicate of the LSC button. You pull the Trigger, the Trigger action happens and then it presses the switch and the switch presses LSC.

Now, if you are trying to duplicate some button sequence that requires a specific timing to pull it off, like after you press LT you must wait some fraction of a second and then press LSC (which is called a macro) then you'll need some kind of micro controller and code written up to handle doing that correctly.

[radek1305]

I was able to do it in the auto fire mode, i.e. soldered two pins and the signal was always fed to the RTC button, but I want it to be connected to the RT button. I thought that by pressing the RT button, a signal is also sent from it ...