Author Topic: 1537 - Only work in Wireless Mode  (Read 1097 times)

Offline renan.horste

  • Fart Sniffer
  • *
  • Posts: 48
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
1537 - Only work in Wireless Mode
« on: July 04, 2020, 03:56:50 PM »
Hello guys, i have a 1537 controller, and he only work in wireless mode, im already test the button board in another MCU board and works fine, so the problem is in MCU board, but WHERE? i have 5v on TP5

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: 1537 - Only work in Wireless Mode
« Reply #1 on: July 04, 2020, 07:43:49 PM »
Measure J5 pin 8 to Ground, should measure 4.5k. If not then check R7 (1.5k) and R8 (3k) for anything missing or a damaged trace.

Measure J5 pin 8 to U1 pin 78, should measure 1.5k. If not look for damaged trace.

Measure J5 pin 10 to U1 pin 10, should measure 0 ohms. If not look for damaged trace.

Measure J5 pin 12 to U1 pin 11, should measure 0 ohms. If not look for damaged trace.


If all of the above checks good, then suspect U1 has an issue.
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline renan.horste

  • Fart Sniffer
  • *
  • Posts: 48
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: 1537 - Only work in Wireless Mode
« Reply #2 on: July 08, 2020, 12:45:49 PM »
thanks mate, my MCU board is Cracked kkkk nothing to do, a lot of traces just jump of.

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal