Author Topic: Xbox elite series 1 board problem  (Read 765 times)

Offline Adampark

  • Chief squatting Hard
  • *
  • Posts: 22
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Xbox elite series 1 board problem
« on: August 20, 2020, 11:04:40 AM »
Hi all, I have replaced a Thumbstick module on elite series 1 board after removing the damaged modular I noticed c27 was corroded so I tried the clean it up and nocked it off the board I cannot replace it with one from a donor board as the pads have lifted too , now The right stick click button is now constantly pressed is there anyway too repair this?

Any help will be appreciated.
Adam

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: Xbox elite series 1 board problem
« Reply #1 on: August 20, 2020, 02:54:07 PM »
C27 missing wouldn't cause that issue, something there is either shorted or corroded on the RSC line to ground.
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline Adampark

  • Chief squatting Hard
  • *
  • Posts: 22
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: Xbox elite series 1 board problem
« Reply #2 on: August 27, 2020, 05:04:19 AM »
Thanks buddy your a genius. Cleaned it all up and now works as it should thanks for your help RDC appreciated.

Kind regards

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal