Author Topic: How desolder button sync xbox one 1537  (Read 496 times)

Offline zis2104

  • Who Farted ???
  • *
  • Posts: 207
  • Post quality +0/-0
  • Acidmods User
How desolder button sync xbox one 1537
« on: October 13, 2020, 02:35:41 PM »
I don't know help me please

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2597
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: How desolder button sync xbox one 1537
« Reply #1 on: October 13, 2020, 03:19:01 PM »
It's a SMT part. The connections are all pretty much underneath it and getting it desodlered with an iron means you'll probably ruin it, unless you use 2 of them and heat the 2 ground points in the front and the 3 main spots at the back at the same time. Be careful as too much heat and you'll just lift the pads/traces.

The proper way to remove/install it would be with a hot air setup and some flux.
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline zis2104

  • Who Farted ???
  • *
  • Posts: 207
  • Post quality +0/-0
  • Acidmods User
Re: How desolder button sync xbox one 1537
« Reply #2 on: October 13, 2020, 06:17:30 PM »
what if i used a thin copper wire and connected it to the various points of trace? i have xbox 360 controller pcb, will i try those for now?

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2597
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: How desolder button sync xbox one 1537
« Reply #3 on: October 13, 2020, 07:34:14 PM »
If you want to rip it off the board and ruin the pads/traces then rewire it be my guest, but that's a mess of work to do versus just doing it the right way.
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline wickated

  • King of the Wii-tards
  • *
  • Posts: 176
  • Post quality +0/-1
  • Acidmods User
Re: How desolder button sync xbox one 1537
« Reply #4 on: October 22, 2020, 05:54:38 AM »
sry i don get wat buton u r toking bout

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal