Author Topic: Ps4 055 board  (Read 1015 times)

Offline Yasso

  • Chief squatting Hard
  • *
  • Posts: 11
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Ps4 055 board
« on: April 24, 2021, 11:47:12 PM »
Hello everyone first of all, I hope someone can help me. I have a problem with a 055 board. R3 is permanently towards the left. in the game he turns on his own axis
does anyone have a suggestion how I can solve this, thanks in advance. below is a picture of gamepad tester
best regards




https://imgur.com/JeenQko

Offline HyperMax

  • Chief squatting Hard
  • *
  • Posts: 14
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: Ps4 055 board
« Reply #1 on: April 25, 2021, 12:46:31 AM »
What happens with your gamepad before? Drops, falls, liquid spill? Smoking vape when playing? First of all you need to examine mainboard carefully, look for a damaged places and parts. Also you can try to clean potentiometers, if it will not help then need to replace analog.

Offline Yasso

  • Chief squatting Hard
  • *
  • Posts: 11
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: Ps4 055 board
« Reply #2 on: April 25, 2021, 09:38:34 AM »
Hi, I've already exchanged the stick, but nothing has changed. the pins for R3 are not damaged either. it doesn't matter which stick I install, nothing changes.

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: Ps4 055 board
« Reply #3 on: April 25, 2021, 10:31:46 AM »
Either the RSX line is shorted to ground or the AN+ for the RSX POT is open.

Measure Resistance on the bottom side of the board from the RSX pin to ground first. If it measures close to 0ohms, that's the issue, possibly a solder bridge somewhere.

Code: [Select]
            3.2v RSX GND
       X                       X

3.2v  R3                        GND
                                RSY
3.2v  R3                        3.2v

       X                       X

X = Mounting tabs for stick and are Grounds

If it measures a few kiloOhms or so, then the AN+ is most likely open to the RSX POT. Install a jumper wire from the 3.2v spot to the left of RSX to any of the other 3.2v spots.
« Last Edit: April 25, 2021, 10:32:36 AM by RDC »
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal