Please, help! JDM-030 burned out component :(

[Eren_Ackerman]

Hello! Thank you, again, for the help the previous time. It helped me a lot <3

This time, a few minutes ago, I was trying to fix a JDM-030 when I got distracted and the flex cable going to the usb port slid a little sideways and the flex shorted. This chip next to the flex connector burned out and I don't know what it is  Please, help me? What is the chip marked in this picture? Thanks in advance <3

[dj_amir]

Hi
This is a diode(d6f). Remove it from the board...try again ds4.

[Eren_Ackerman]

Thank you, dj_amir 

[Eren_Ackerman]

Update on this case:

I bought a soldering station Baku 702b now that I'm trying to learn this for serious. I removed the burned out d6f diode, and then instead of leaving it without it I decided to replace it with another one that I found in a faulty usb board from another jdm-030. Today I was able to test it because I bought yet another jdm-030 and tested this controller from this post and it's working just fine. Now I need to buy jds-030 replacement boards xd

Thanks again for the info <3