« previous next »
Pages: [1]   Go Down

Author Topic: 1708 no power due to MCU board  (Read 577 times)

Offline APintoZ

  • Chief squatting Hard
  • *
  • Posts: 14
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
1708 no power due to MCU board
« on: November 19, 2022, 01:14:53 PM »
Hello,

I have a 1708 controller which doesn't power-up when the guide button is pressed. I checked and everything is fine with the button/power board, and when I replace the MCU board with another one it works fine. So, the problem is with the MCU board. Does any of you have a hint on where to start? Thank you!

AP
Logged

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2597
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: 1708 no power due to MCU board
« Reply #1 on: November 19, 2022, 03:12:06 PM »
Inject 3.3v into that MCU board on the 3.3v rail and see what gets hot first. If it's a Cap, remove it, then try it with the top board again.
Logged
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline APintoZ

  • Chief squatting Hard
  • *
  • Posts: 14
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: 1708 no power due to MCU board
« Reply #2 on: November 20, 2022, 05:02:23 AM »
Thank you! I'll look at the schematics and find the 3.3v rail and try!
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal