Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
Clicking is usually a short on a fuse or such.
ahhhh i see you are useing the speaker audio out put that is your problem. use the headphone audio and you will need a switch on 3 and 4 to activate the headphone audio 1 is left audio 2 is right audio 3 is ground and 4 is detect pin i think
Robin I r sorrieez.
Nice stuff man. You did this faster than I expected lol. Hope the fitting ect... goes well. Oh and remember your promise about that mini tut
told you b4 to solder to headphone jack point hehesounds quality are much important then the loundness...
pictures?
Good to hear you got this working thane! you should post a vid and some pics of it working so we can have a pop at it.
nice man. It looks good. But yea you'll needa figure out how to get the umd to shut. Can't you just cut away some of the stuff behind the umd(like behind where the umd reader was) away and then it will be all good?