PsP Laptop

[aToMiiK MaGiiKArP]

Finally a psp laptop... but no keypad...
it simply moved the screen up from the psp front case then cut away the top of it. the psp screen then was covered in black wire tape due to my psp being black and white. all works )))

[TheBboyKnowledge]

can you make a tutorial on how to do this?

does the psp still have all functions?

this is tight!

[aToMiiK MaGiiKArP]

Yea np i make a tutuorial, it stilll has all of the functions/all buttons and  analog and screen works

ok heres the tutorial...

1. Take of you psp faceplate

2. Unclip your screen from the metal piece holding it to the psp

3. then on the top of your psp faceplate, where those little holes are up the top/infront of  your umd drive you need to use a knife and cut that top bit of.

4. lift the psp screen up but DO NOT PULL IT AWAY FROM THE MOTHERBOARD!!! then re attach your case--- the bit you cut out should be wide enough for the ribbon cable to fit through.

5. screw it all back together, you made neeed a bit of superglue if neccisary.

6. i just got some black wire tape here and put it round my screen to not only hold it up but also to suport it otherwise i would hyper extend the ribbon cable. i sugggest using wire tape because it looks neater than maybe selotape.
Post Merge: February 16, 2010, 02:53:36 AMFinally vid of it!

[n00b_MoDdEr]

its ok... i just would owrry that the top screen would work...ya know what would be badazz if you had lost of soldering skill? soldering a top screen AND having the bottom screen on, though it would suck up ALOT of power....DUAL SCREEN!!!(no point wutsoever....heh i like those things...)

[aToMiiK MaGiiKArP]

its ok... i just would owrry that the top screen would work...ya know what would be badazz if you had lost of soldering skill? soldering a top screen AND having the bottom screen on, though it would suck up ALOT of power....DUAL SCREEN!!!(no point wutsoever....heh i like those things...)

Confusing...