Trigger Mod doesnt work

[psp339]

I did the trigger mod exactly how the diagram shows. I soldered the positive to the part where u scratch the paint off and the negative to the end of the resistor on the powerboard. When I turn on the psp, the lights do not turn on. The psp turns on fine. What did i do wrong?
+~~~~~~[resistor]~~~~~~~~~[LED]~~~~~~~~-
                           \~~~~~~~~~[LED]~~~~~~~~-

[*FuFa]

I did the trigger mod exactly how the diagram shows. I soldered the positive to the part where u scratch the paint off and the negative to the end of the resistor on the powerboard. When I turn on the psp, the lights do not turn on. The psp turns on fine. What did i do wrong?
+~~~~~~[resistor]~~~~~~~~~[LED]~~~~~~~~-
                           \~~~~~~~~~[LED]~~~~~~~~-

Are you sure you're LEDs are the right way around?

[psp339]

Yea. Im pretty sure i have them the right way.....  positive [|-] negative
EDIT: NVM I just took out the resistor and now it works  .
I think my resistors are wrong. accidently bought 10 ohm SMD resistor.

[platinumc]

you need to use 10 ohm resistors lol

[psp339]

I read that you can use without resistors. It worked then stopped working so i gave up. I took it out and now the power and charge LED doesnt work. What happened?

[DubbleDutch]

I read that you can use without resistors. It worked then stopped working so i gave up. I took it out and now the power and charge LED doesnt work. What happened?

i had thesame problem
u'll have to replace the ribbon cable from the motherboard to the powerboard

[platinumc]

I read that you can use without resistors. It worked then stopped working so i gave up. I took it out and now the power and charge LED doesnt work. What happened?

yeah you can use blue leds w/o resistors, but what i meant was, according to your previous post, that 10 ohm resistors are the right ones you need to use, if you use them

[GhoSt]

its safer just to keep a 10ohm in just to jive you peace of mind of not burning you hard earned 0603's? or worse a psp PSC!!!