« previous next »
Pages: [1]   Go Down

Author Topic: led hellp  (Read 934 times)

Offline nevekd128

  • ♪♪♪ Tone deff ♪♪♪
  • *
  • Posts: 61
  • Post quality +0/-0
led hellp
« on: May 08, 2008, 11:58:02 PM »
my wifi led kinda broke off when it got dropped. but i have some 0603 blue leds from my trigger mod left over.... can i just glue it ont the board?
with like super glue or locktight
 water proof glue?
Logged

Offline ApheX

  • Club AM VIP
  • Millennium Poster
  • *
  • Posts: 1094
  • Post quality +1/-0
  • Gender: Male
  • PSP And PSP Slim Case/Hardware Modder
    • ApheX MoDs
Re: led hellp
« Reply #1 on: May 09, 2008, 01:22:11 AM »
wouldn't recommend it. if it doesn't work then you'll have to clean all the glue off the contacts which is not fun and could damage the mobo. are you not able to solder it back on?
Logged

Offline celph_titled

  • Chief squatting Hard
  • *
  • Posts: 18
  • Post quality +0/-0
  • Gender: Male
Re: led hellp
« Reply #2 on: May 09, 2008, 07:29:34 AM »
how are you to solder it on that looks kind of trick.
Logged
(+.[FAT]%) 1.50  to play crisis core. Brick well updating to 3.73 (+.[SAD]%) Pandora 3.71 m33 (+.[YES]%) 3.71 m33 -2> 3.71 m33-3> 3.80 m33> 3.80 m33-2> 3.80 m33-5> 3.90 m33> 3.90 m33-2> 3.90 m33-3 install time machine v.01 and went back to 1.50

VoX

  • Guest
Re: led hellp
« Reply #3 on: May 09, 2008, 07:41:33 AM »
If you have done the Shoulder LED mod then you should be able to solder an LED back on. All you have to do is solder it on where the WiFi LED was, but make sure you have the Polarity right

- Vox
« Last Edit: May 09, 2008, 07:45:08 AM by VoX »
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal