« previous next »
Pages: [1]   Go Down

Author Topic: Matrix board  (Read 1206 times)

Offline killshot88

  • Guppy
  • *
  • Posts: 1
  • Post quality +0/-0
Matrix board
« on: October 24, 2008, 11:09:22 PM »
I am pretty shore i have an old matrix board. According to the pics that some people have posted. I have connected to middle prong and when i connect to led it does rapid fire but wont stop it continues to fire .i know the switche work. any ideas on how to correct or should i just go buy a new controller and start over.
Logged

Offline cory94bailly

  • Club AM VIP
  • Chief squatting Hard
  • *
  • Posts: 17
  • Post quality +0/-0
  • Gender: Male
Re: Matrix board
« Reply #1 on: October 25, 2008, 09:21:25 AM »
Quote from: killshot88 on October 24, 2008, 11:09:22 PM
I am pretty shore i have an old matrix board. According to the pics that some people have posted. I have connected to middle prong and when i connect to led it does rapid fire but wont stop it continues to fire .i know the switche work. any ideas on how to correct or should i just go buy a new controller and start over.

Does it not stop until you press it again?

Is the button a momentary switch?
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal