« previous next »
Pages: [1]   Go Down

Author Topic: Breadboard + Multimeter?  (Read 2468 times)

Offline PhenomenalDesigns

  • Granny Spanker
  • *
  • Posts: 476
  • Post quality +0/-0
  • Gender: Male
Breadboard + Multimeter?
« on: January 12, 2009, 11:24:03 AM »
Need some help, ill make it quick and snappy since I want to play CSS, Whats the easiest way to get multimeter prongs into breadboard (my powersupply has multimeter prongs)
Logged


Hoi! Pinoy ako!

Offline 00G

  • Fart Sniffer
  • *
  • Posts: 42
  • Post quality +0/-0
  • Gender: Male
  • Woohoo, 1/2 more and I'm a pint!!!
Re: Breadboard + Multimeter?
« Reply #1 on: January 12, 2009, 11:01:12 PM »
Are you joking?  In a pinch, I would wrap the wires on the prongs then insert them onto the board...  A little electrical tape for safety?  I actually have alligator clips on the end of my probes as an alternative....
Logged

Offline PhenomenalDesigns

  • Granny Spanker
  • *
  • Posts: 476
  • Post quality +0/-0
  • Gender: Male
Re: Breadboard + Multimeter?
« Reply #2 on: January 12, 2009, 11:41:08 PM »
Quote from: 00G on January 12, 2009, 11:01:12 PM
Are you joking?  In a pinch, I would wrap the wires on the prongs then insert them onto the board...  A little electrical tape for safety?  I actually have alligator clips on the end of my probes as an alternative....
Im not joking, i need to connect my PSU and my Multimeter to my breadboard, and not just temperaily, I need it there quite long and I dont have any proper breadboard leads

EDIT: Done, I just snipped the extra leds off a few leds and soldered it to the prongs of the multimeter leads
« Last Edit: January 18, 2009, 02:43:41 PM by PhenomenalDesigns »
Logged


Hoi! Pinoy ako!
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal