Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
;***** FIRERATES *****************************************************FIRERATE1 equ .167 ;6 spsFIRERATE2 equ .250 ;4 spsFIRERATE3 equ .125 ;8 sps;to get desired speed divide 1000 by your desired sps then enter;it here and recompile and reprogram the code;Example: 1000/4 = .250;**********************************************************************
ive tryed to install this in 3 diff ps3 controllers and cannot get it to work ive tryed the precompiled hex supplyed and ive also tryed compiling it my selfne ideas? ive checked all the wires
Hyper if you remember i had the same problem that elimarz ( i had to press the chip with the fingers)Believe me guys i think isnt only a problem with the chip or connections. I have done enough intallations in xbox controllers and i have never problems. Have you tried or checked the code just for a moment?? I say this because when i did it the first time the code worked fine but some days after the problems began. A friend told me that he had problems when he charged the controller. If you can, test it day a dayI have tried with a rf kit i bought on ebay also and works without problems. The only thing i can think that could be the reason is the resistor, i didnt put it but the resistor is for the led so i dont think it will be the reason.
elimarz i do not have a vx4 controller so cannot personally test it but i have tested other boards so i do not know why it is not working for you and im not saying there is deffinately wrong with your install but the symptoms described would happen if there was an incorrect connection as for it working when you touch the chip that is probably due to your finger shorting the pins or due to esd from your fingersomething you guys can test is if you connect the com2 pin(the pin on the chip) to ground, the chip should change modes and the leds should work but rf will not, if this does not work then there is a problem with your setup (most likely with incorrect pins or connection to power or ground