Ok First of I'm not responsiable for what you do or your mistakes.********************************************************
Ok this Tut is going to show you that you dont need the umd cage on a fat psp
********************************************************
<>First of what you need:
<1>Small Screwdriver
<2>Small Flathead
<3>A Bowl to put all the screws in (opitinal only so you dont lose the screws)
_______
________________________/Step One\_______________________________
Disimable your psp all the way to the mother board to do that first off you need to remove these screws
once you've done that you should have this
Now what we have to do is remove the button board like this
once done that release it from its clamp and take it out
now we have to remove the lcd screen by gently pushing your small flathead down the side and
lifting it up as example:
<a href="
http://s267.photobucket.com/albums/ii299/lil_miss_frizzy/?action=view¤t=01170620044.jpg" target="_blank"><img src="
http://i267.photobucket.com/albums/ii299/lil_miss_frizzy/01170620044.jpg" border="0" alt="Photobucket">[/url]
this bit is pretty hard dont worry if you cant do it took me like 4 hours to figure out how to remove the screen.
once the screen is out of its cage you need to remove it from its clamps like this.
once done that we need to remove the LCD screen cage to do that you have to remove the screws
pointed out in this pic.
once done that you have lightly pry/push up the cage so it comes out (by the way u need the umd door open
to do this)
once done that you will be at the mother board =]
now what we have do is pry the umd door cover hinge which is pointed out in the next pic
(excesive force will brake the hindge witch is bad)
once done that the umd door cover should just pop off =] (nearly done)
and you should have this
once you have that you have to push the cage off it hindges like this.
(push it the the way it points on the pic)
once done that you should have this
now we have to clip the door on by putting <----------------- this side in first:
then push in the other side
=] your done!!! test your door out and see if stays in! if it does SUCESSS BOO YEH!
(i swapped psp's beacuse the one i used in this tut is briked)
===============================================================
How to put the umd in
Ok first off hold the umd disc in the hole thingo where you put your discs in
then start to put it down
then you should feel like a magnetic force beacuse your getting close to the acctuall reader (thats
a good thing)
once its in it should be stable and wont just fall out.
shut the door
test it out
!!!!!!!!!!!!!!!!!! IT WORKED!!!!!!!!!!!!!!!
PM me if you have any problems =]=]