Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
You might of ripped the rippen, or disconnected the cables, but i dont think so because if u disconnect the ribben and start it up everything goes bad.
Buy a DS3, MGS4 uses it so much anyway, your missing a whole sense by not having one!
go to walmart or whatever and buy some when you get to the car open and swithc them out. and go back and say oh sorry i just found out my mom just bought me some. that worked with my broken wii motes lol
i also think it might be the ribbon cable, it might not be fully inserted or put in properly and so then the buttons wouldnt work, thats the only solution i could think of
well i had a similar problems where it wouldnt work but this was because i had some solder joining 2 pins on the connector of the board together so it was :censored:ing up the controller, so just make sure the pins on the connector are free from excess solder
if its missing some screws just go find some and make sure that lady at walmart doesnt check to see if the controllers is loose or anything