Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
whats a good cheap programmer to write this code to the chip.
If wired right, will this work the same as the sleeper or is the sleeper a whole different hex?
there every one happy there is the wiring Digrams for one or 2 swtichsThis works on both Type of Controller Old and New Style Wireless no resister neededI tested on both wireless so please test it on wire one and let me know.
i just tied it on a wired controller and followed the diagram and the controller would not swith on and then the chip started burning and went very hot.hope this helps and will be awaiting your reply
sure you didn't confuse pin 1 with pin 8? its very easy to get them confused when its in "dead bug" position, as in upside down. i should know, happened to me
i just tied it on a wired controller and followed the diagram and the controller would not swith on and then the chip started burning and went very hot.
ill buy the cheap programmer from there but do i need a serial cable to connect that to? because i see like a thing sticking out for power.
Right, but what I want to know is if I could have both right and left triggers function as rapid fire through two different R and L buttons attached to the controller. I want 2 outputs to come from pin 5 to go to 2 different triggers. The way he has done it in his video is that the two buttons both fire the right trigger.