Author Topic: led wiring  (Read 1531 times)

Offline blackwid1

  • Chief squatting Hard
  • *
  • Posts: 22
  • Post quality +0/-0
  • Gender: Male
  • PS3 , PSP, XBOX 360 MODDER
led wiring
« on: September 27, 2009, 01:19:40 PM »
ok so i got all my leds soldered and they all work but i tried putting my psp back together again and they wont work now i think its cause my wires arent in good areas could someone tell me where i could find a pic of someones led mod totally finished so i know where to run my wires.  Thanks

Offline [HoP]

  • Ex-AcidMag
  • Granny Spanker
  • *
  • Posts: 361
  • Post quality +9/-3
  • Gender: Male
Re: led wiring
« Reply #1 on: September 27, 2009, 04:20:43 PM »
what i would guess is that one of your LEDS grounded out on some shielding, the psp has a buttload of shielding.

another thing, i personally dont use the magnet wire, if that is what you are using.... the resin comes off of it quite frequently causing shorts and failures. i only use that in extreme cases, or places where there isnt metal for it to ground out on.

good luck, and check for pinched wires!

Offline blackwid1

  • Chief squatting Hard
  • *
  • Posts: 22
  • Post quality +0/-0
  • Gender: Male
  • PS3 , PSP, XBOX 360 MODDER
Re: led wiring
« Reply #2 on: September 27, 2009, 07:37:00 PM »
ok so to prevent shortages would i use electrical tape or something

Offline Demonboy

  • MFH
  • Granny Spanker
  • *
  • Posts: 362
  • Post quality +6/-0
  • Gender: Male
  • hunterish
Re: led wiring
« Reply #3 on: October 26, 2009, 05:28:38 PM »
what i used was some stuff called gorilla glue at the bottom of my leds it dries like caulking or hard foam and is a good isulator only thing is u have to let it dry b4 u put them in otherwise it will just glue it to the psp and then ur screwed sideways

lol look at this crap u can get like 5 bucks a day for doing  poop http://adf.ly/2Knsr

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal