New proyect Analogs Ps3 style [FINISHED]

[totolia]

Hello good, my name is Adria and I am starting with the modding.

Hize already some projects such as "Xbox controller Air Cooler" (They have internal fans that are cool and not sweat).

I am currently trying to leave half what this fellow https://www.acidmods.com/forum/index.php/topic,39044.0.html. What he has done to move the stick, is not difficult.

The question is how to move the arrow arrives where is the analog, could provide a schema if you know where to solder?

Sorry my English is basically "Google Translator". Thanks for everything

[1TONpete]

I think you want to switch the dpad for analog on your controller?

For rewiring analogs its just wire the 3 pins from each sensor to the controller where the pins where before. pins are vcc , pole , and ground.

[totolia]

I think you want to switch the dpad for analog on your controller?

For rewiring analogs its just wire the 3 pins from each sensor to the controller where the pins where before. pins are vcc , pole , and ground.

Nono, I mean the left bottom crosshead. I wonder where I welded to press for example above, or below, and so on.

[1TONpete]

You want to know how to wire the dpad up down left and right to the left analog , correct?

[totolia]

If accurate, the problem is not where to weld the new buttons. If someone could indicarmelo because you'll not find anything. Thank's

[Phantom]

you can scrape the black covering off the d-pad contacts and solder to it, not really sure if thats what your asking though. i took alot of pics when i did mine, so you might find what you need in my post here: https://www.acidmods.com/forum/index.php/topic,37849.0.html

[totolia]

A picture with bad resolution, soon get better.

[1TONpete]

When you use the stick do you want it to act like a stick or a dpad? If you are just doing a swap of the dpad and stick, you just need to wire the stick to the pins for the analog and the dpad you can scrape the black covering off the contacts and soled to that. I dont know what board you got of I can give you more specific info on where to solder.

[totolia]

The esthetics of the control I Intended to be very similar to the PS3 style. It all works correctly, I can only wait for it to dry and finish the case improvement.

[totolia]

Finished, the result can be seen here. I think it has been pretty good;)