superman logo cut???

[DARk_ANGEL]

ok guys someone wants me to cut the superman logo out but he wants the 'S'  but how can i cut this out with it showing the s and the dimond thing?

hers a link

[Rodent]

It can be done, just going to have to do it in sections. seperate peices hard to explain,

[Crumbz]

well he could just cut out the logo so that the "s" and diamond shape are cut out the seal it back together with a clear resin.

[Monk3y]

Cut everything in yellow out, then also cut out a border around the diamond.

[Rodent]

Laid it out below think that will work the best.

Edit: If you dont like this idea you could paint the S and use Yellow leds, let me know what you think about it .

Cut everything in yellow out, then also cut out a border around the diamond.

Was thinking the same thing as Monk3y cutting out around the board a diamond that way you could see the plexigass around the shape of the diamond

[1TONpete]

Guys see the cut out I did for CMM that is the best way to do this.

[hyper999]

Just cut everything out put plexi behind the main cut then stick the little bits on the front of the plexi like this



(although I think paper was used for the middle bits here instead of plastic from the case)

[1TONpete]

Yes like this I'm saying with yellow paper where the red is tho. If you use the stuff I used you can print up the whole thing in transparent color and have it glow 2 different colors from 1 color light.

[DARk_ANGEL]

i like this its a good job on it im thinking of doing that then