Flex Pcb needed

[CptChronic]

Can anyone on here make a flexible pcb on CAD for me or know someone that will please? I need it for the xbox one S controller.

If all goes well I'll also have one for the older xb1 versions and maybe PS4 too. With a new one everytime a new version is released.

Obviously for cash.

Thanks

[RDC]

FPC design isn't much different than PCB design when you get down to it. The design parameters of it would dictate most of the cost, but that can get into a real mess depending on if it needs to be tested first, redesigned and so on. Expect having the actual FPC made to be more expensive by comparison to a similar PCB design. It also costs a bit more on the assembly side if you're going that route. 

[CptChronic]

Thanks for the reply RDC. I know it's not going to be cheap, been thinking of trying to make one myself but I have no knowledge on cad at all.
At the moment it's taking me around an hour to install this new mod, so many wires  plus it's an 18f chip so soldering it to the mini circuit board before installation to the controller is a nightmare as the legs are so small and close together.
The other one I have only takes 5 minutes but isn't as good so I need to get moving with the new one.

The one you have posted there would be perfect, it's a different chip though