« previous next »
Pages: [1]   Go Down

Author Topic: tp25 and tp17 short 1708  (Read 650 times)

Offline imran421

  • ½ Pint
  • *
  • Posts: 32
  • Post quality +0/-0
  • Acidmods User
tp25 and tp17 short 1708
« on: May 20, 2020, 01:05:39 PM »
I have aboard that has tp25 and tp17 short. So when press up botton then menu also lights up vise versa.
Is U4 chip is short and needs repalcement?
Thanks
Logged

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: tp25 and tp17 short 1708
« Reply #1 on: May 20, 2020, 01:56:57 PM »
TP17 is DD (D-pad Down) and TP25 is View.

DU (D-pad Up) is TP16.
MN (Menu) is TP24.

If you do mean TP25 and TP17 then the first place I'd look is U4 pins 14 and 15 since they are right next to each other, possibly a solder bridge there.
Logged
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline imran421

  • ½ Pint
  • *
  • Posts: 32
  • Post quality +0/-0
  • Acidmods User
Re: tp25 and tp17 short 1708
« Reply #2 on: May 20, 2020, 02:26:35 PM »
WOW you were dead on. It was bridge. Remove the excess solder and every thing is good.
Thanks again
Logged

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: tp25 and tp17 short 1708
« Reply #3 on: May 20, 2020, 02:28:49 PM »
Welcome.
Logged
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal