Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
My initial thought was the analog potentiometer needed to be replaced but you said you replaced the whole module twice, I?m assuming with the new ones. From the looks of the motherboard, it may be damaged and that could be causing it? I would?ve done the same steps you did, if it still didn?t work. Motherboards no good🤷🏽♂️ Or try the module on a different motherboard.
Some of those vias look like they have been torn out, so that X-axis POT probably isn't getting it's 3.2v to it.
O O+ L3 +Y- L3 + O O - X +
Jumper wire from a good 3.2v spot, like the Y-axis 3.2v spot, to the lead of the X-axis 3.2v spot. Bottom of the board, how your pic is. Code: [Select] O O+ L3 +Y- L3 + O O - X ++ = 3.2v- = GroundX = X-axisY = Y-axisL3 = L3 buttonO = Solder lugs for the Stick, Ground
Ok, I did what you said and is better but not perfect :/Please take a look:https://ibb.co/FBH24pfDo you have any suggestion, please?
@zis2104, @ChrisJavier - ok, thank you, I will do that and let you know
Don't try this https://youtu.be/MIDa3WeNZDI
Thanks for sharing the video. I've ordered some trimmer pots and I'm going to try it soon