[BDM-030] Right Stick moves to the left - probably damaged a via

[SchwarzerAfri90]

Hey everyone,

I got a problem with a BDM-030 after installing hall effect sticks.

The right stick is constantly moving left. I damaged the trace for the up/down movement and fixed that fololowing the advice of RDC to remove solder mask an solder on a jumper.

The problem is that that all the traces for the left/right movememt seem intact, also the vias.
Also the sensor gets his voltage from the other axis via jumper. Also continuity-measured  the three legs , the middle leg is neither grounded nor has i visible broken trace.

What could that else be ? The controller was working fine before.

[SchwarzerAfri90]

Can be closed, was just stupid. New Sticks had shorter legs and the middle via hat a bad solder joint