THERE ARE 2 WAYS TO DOO THIS. WATCH SECOND VIDEO!!!ok guys, here you go. i decided to make a new internal dual nub for those of you who are trying to make them. this only shows you how to make the nub. it is 100% working and one of the best ways to make a dual nub for your psp. it is similar to wetfusions dual nub but i am using the track pad on the nub for the wiring
DSCF3076ACIDMODS: PSP dual nub tutorialREASONS why its easier and better to make than wetfusions ( NO affence bro your still the reason i made this one!! you started it all! its just my version of your style
):
1) no grinding the nub
2) easier to make
3) no melting of the nub while soldering wires
Difficulty Rating :2.5/5
TOOLS:-soldering iron and solder
-helper hands (optional)
-kynar wire
-PSP 1000 nub (2000 may work)
-dremel (optional)
-needle
-hot glue gun woth glue sticks
All you for parts is:step one: get the nub's trace board
step two: grind down the traces as shown in the photo below
step three: put holes on both ends of the black line trace's [ V1]:
[size=8]
OR[/size] [ V2 ]
put holes on the sides of the trace
step four: cut a wire about this long and strip the protective coding off as much as shown in the photo
step six: solder the wire through the holes where the old contact points the the nub use to be [ V1 ]
step seven: cut off the wire closest to the end of the coding and solder it through the last hole on the nubs old trace board.
then you must solder a wire to one of the point circled in red. DONT PAY ANY ATTENTION TO THE OTHER WIRE. THATS A LATER STEP!!
step eight: put a wire through the bottom of one of the trace's and solder the two ends together. repeat this step for the rest of the trace's.
OR [ V2 ]
step nine:THIS PART IS VERY IMPORTANT!!punch two holes on the circle trace where it sticks out
step ten: VERY IMPORTANT ALSO!! next but a wire through the holes to it WRAPS around the trace and TOUCHES IT!! this is your
GROUNDstep eleven:
THIS IS THE MOST IMPORTANT PART!!! you must uses pliers to squeeze the wires and solder as flat as possible.
step twelve: next cut of and smooth out the bottom part of the nub stick that goes inside of the nub.
step thirteen: put together the nub
DSCF3071step fourteen: keep it all together with some glue
DSCF3072step fifteen: install it. use the first four steps of my tutorial for the External dual nub for:
PSP 1000https://www.acidmods.com/forum/index.php/topic,35124.0.htmland
PSP 2000 ONLY use the first pic/ schematic
step sixteen: grind doen the area where the nub is going to go on your faceplate. make sure you dont grind all the way through it
Install it and put your PSP back together.
ENJOY!
PROOF
DSCF3073
Post Merge: October 10, 2010, 05:57:02 PM
ok guys it has been updated. there are two ways to do this. you choose which one you want to do.