Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
Its The Nand X Usb Update Cable That He Might Need. Other Wise He Can Hust Make One Out Of A Spare Usb Cable I Believe. Also When Xells Boots, It Literally Says Cpu Key, Dvd Keys.
coronas might have to us Jr programmer cable update idk if you have one of those. most read the key with com port
you Will Also Need A Max232 Serial Ttl Reader Along With That Usb Cable.
Okie will I need to follow this kind of schematic when building one http://sodoityourself.com/max232-serial-level-converter/
that image is for a Trinity board not a corona so do not install the wires as shown in that pic you will need all the wires as colors are shown here for corona but idk if you need to add them wires since you are using 4gb SD Card http://gyazo.com/f87b2bfc0adfce1c6ad49fc0925fe98c
Oh thank you Rodent I went ahead and downloaded the image kind of small for my eye to see so I will blow it up. Hmm okie So I might have to hold up till we can figure out if someone knows if I need to do all the connection or not for the 4gb corona. But for the color combination look of it I need the one with the two 2 pin and one 3 pin connection end.
look on j-runner all images are on j-runner
have your read the nand yet? i thought that is what the 4gb sd card is for? so you could read/write and be done
Lol yes I got the nanddump 1-4.bin so I was able to read it but Gizmo says I have to set CR to corona time using either NANDx or Jrprogrammer. Then I can create my ecc write it to CR and boot xell so i can get the DVD key. Read up from the Max232 back to where Gizmo said I will require the tool, it will bring up to date haha.
you have to program the coolrunner . so you need a jtag cable to go from the J-runner to coolrunner so you can program it. as of right now you can write the ecc just it will not work untill you program the cool runner for the corona you have so 1st you have to disconnect power from the xbox. use the jtag cable hook it to the j-runner and and flash the cool runner thru j-runner.then you can unplug the coolrunner from the jtag cable and the cool runner will be flashed. Read my tutorial on how to flash the coolrunner.
Make Sure To Move The Coolrunner switch Form Nor To prog
It Has A Long Black Plug That Is Labeled. Like Vcc,Gnd,Tmo,Tsk etc..
[smg id=2916]
Thank you guys found it, okie so I am setting up right now to program the CR. So I am at this point, what do I press? Need to look at the CR setting right?? whether or not its set to 2-3 or 3-1 or 2-1
those are the timing files you will have to test them for best boot times.
Same as snowcolt you need the updated version of lib win32 for x 64 bit http://www.libusb.org/wiki/libusb-win32