Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
I am going to add something here:1. Is the wiring completely installed? Some people leave out the left trigger and/or the left LED. This could cause problems that would not normally be picked up.2. If the wiring is complete, then my code would not work correctly if there was a mistake with the wiring as is being suggested by everyone else. But make sure you test everything. The left trigger should also rapidfire when enabled with the left tact.3. The problems you are describing only happen with this one game. Describe the unwanted behavior, but also tell us what button would normally cause that action in the first place under normal circumstances.4. You say these problems exist even when the chip is 'turned off'. What does that mean? Is it the first mode where the RF is disabled? And what I find interesting is you are basically saying that the GameplayRF code does not cause this behavior, on or off. Is that correct?In my opinion, looking at those 4 questions there seems to be more to this than simply saying its a bad install. If it was a bad install, there would be obvious problems with GameplayRF especially since that code performs ADC on reset to determine controller type. It would act very strange on a bad install.
this isa very odd set of issues your having.. and i would like to test this out.. but i dont have BF 1943..isnt BF 1943 the bf arcade game they released???and also have you tried the on BF bad company???? if so i can test out on that game as i have it....also if anyone else has bf1943 it would be nice if you could test this and get the same results so we dcan start undrstanding the issue with it......it just sounds wierd to me that the RF is effecting a anolog click.....
Not to odd, if the left trigger pot is thinking its pulled, you cant sprint.. its like BF is more sensitive then cod.
the leds are backwards though. dont forget lol
Hey buick could you post a photo of your controller with the icsp socket? thank you and sorry for the off topic
Buick: Nice, Did you isolate the programming voltage? (13v)If you wana help around id like someone to make a simple ICSP tutorial or even scematic for other people to use, just something with a jack or usb on.Also t0pFire is going to get updated pretty soon. I want some suggestions. Shall i swap the LED's same as Hazer's? so reflashing the PIC is a perfect install for both code's.Remove some modes? make mode changing quicker? make all modes reprogrammable?Need some suggestions for 00.3. or possibly a revision update.
@ buick455 why wouldn't you just have an external 8 pin socket, then you can just pop the chip out and reprogram it and put it back in. much cheaper... i bought like 50 sockets for $1 on ebay.thanks t0p
You should drop it to like 5 modes and add a jitter mode, rewiring the leds would be a good idea... Greatwork @ buick455 why wouldn't you just have an external 8 pin socket, then you can just pop the chip out and reprogram it and put it back in. much cheaper... i bought like 50 sockets for $1 on ebay.thanks t0p